![]() Leaving the channels function set to Source number of channels is fine, so long as you don't try to play something with more channels than you have physically present. ![]() ![]() Those your output device handles natively, are passed through untouched, and MC will only resample those it must. You want to set it so that it does resample those formats your output device does not support (which would otherwise fail to play) to the highest sample rate available on your device. Instead, enable the Output Format DSP, and make sure it doesn't resample any formats your output device handles by default (this is easy to do, and the defaults are usually very safe). You'd have to actually go through a bit of work to get it to do that, in fact! MC does not just "resample everything" if you have that turned on (Matt isn't an animal). People do this without understanding what MC does here. This does not improve quality in any way, and will make playback of some formats fail (anything with a sample rate too high, or low, for your hardware will fail to play back entirely). Unchecking the Output Format DSP disables it. MC's Audio Path function will show you the details of what it is doing as well, and you probably won't have that level of control or feedback on your receiver (which could be doing who-knows-what to the encoded audio). MC decodes it, and then sends pristine PCM, uncompressed audio down the HDMI wire to your receiver. Otherwise, there's no difference between this and what MC would be doing with your audio files in, for example, FLAC format. But once you do this once, then you're done, and MC can decode DTS-MA too. If you have DTS-MA formatted video files, it is a tiny bit easier to bitstream those formats, because for MC to decode those, you need to get a third-party DLL and put it in a place where MC can use it. It makes the pretty lights light up on your receiver? It has that going for it, I suppose. I've also found that MC generally does a better job than my Denon and Yamaha receivers decoding Dolby Digital (AC3) in troublesome streams (such as those from my cruddy Time Warner cable box, where both my Denon and my Yamaha choke and skip, and MC decodes the same audio streams perfectly). Over HDMI? No, and it prevents you from using some quality-improving functions within MC such as VideoClock. I know it must be a pain to keep explaining the same topic over and over again to those of us still on the learning curve. If not, and I should bitstream, should I select custom and check all or some of the formats? If I understand what I read in the forums the above should send an unchanged pcm to my reciever - which would be just as good as bitstreaming. I've selected Nividia High Def Wasapi which is my hdmi out to my receiver. I've disabled volume, and unchecked output format (encoding - none, source for number of channels). I'm trying to deliver an unchanged signal to my receiver and let the DAC in the receiver convert to audio. I'm trying to understand if bit-streaming would offer any advantages. One last question and I can let my settings alone. ![]() I've finally got my system so its outputting audio over HDMI to my receiver without downsampling or reducing channels.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |